(placeholder)

Photos

piece for inner guard made
piece for inner guard made
Old metal cut away
Old metal cut away
Checking the new piece for fit
Checking the new piece for fit
Badly corroded boot floor exposing equally corroded rear body mounting support
Badly corroded boot floor exposing equally corroded rear body mounting support
New rear body mounting support made
New rear body mounting support made
Carefully cutting away the existing corrosion
Carefully cutting away the existing corrosion
New upper internal section made
New upper internal section made
New piece butt welded into position
New piece butt welded into position
Rear guard mounting edge showing signs of previously poor repair
Rear guard mounting edge showing signs of previously poor repair
New piece was hand formed and butt welded
New piece was hand formed and butt welded
Chassis ready to strip down
Chassis ready to strip down
Chassis being rebuilt
Chassis being rebuilt
Pre fitting of wide wheel arches
Pre fitting of wide wheel arches
Re-shaping pre formed panels to correct contor
Re-shaping pre formed panels to correct contor
Butt welding new panel to existing guard
Butt welding new panel to existing guard
Fully welded and smoothed
Fully welded and smoothed
Cold galv primer is used to prevent rust forming prior to painting
Cold galv primer is used to prevent rust forming prior to painting
Time to move onto the rear gurad
Time to move onto the rear gurad
After removing the excessive metal, the new guard is Butt welded and smoothed
After removing the excessive metal, the new guard is Butt welded and smoothed
A spoon shape dolly is used to smooth out the weld on this internal sweeping curve
A spoon shape dolly is used to smooth out the weld on this internal sweeping curve
Again, cold galv primer is used to protect the works
Again, cold galv primer is used to protect the works
Here we have an unwanted sunroof hole
Here we have an unwanted sunroof hole
A new piece is hand formed and butt welded then smoothed ready for painting
A new piece is hand formed and butt welded then smoothed ready for painting
A new piece had to be made to repair a previous unsatisfactory repair
A new piece had to be made to repair a previous unsatisfactory repair
Repair complete and a lot cleaner looking
Repair complete and a lot cleaner looking
MG TC arrived in boxes
MG TC arrived in boxes
The works are almost complete
The works are almost complete
MG TC now in the rebuild stage of restoration
MG TC now in the rebuild stage of restoration
Falcon XA GT pre diamond blasting
Falcon XA GT pre diamond blasting
After blasting the works commence
After blasting the works commence
Holes in window surround
Holes in window surround
New pieces made and fitted to make good for new windscreen
New pieces made and fitted to make good for new windscreen